Experimental, computational, and dimensional analysis of the mechanical performance of fused filament fabrication parts
Process parameters in Additive Manufacturing (AM) are key factors in the mechanical performance of 3D-printed parts. In order to study their effect, a three-zone model based on the printing pattern was developed. This modelization distinguished three different zones of the 3D-printed part, namely co...
| Autores: | , , , , , |
|---|---|
| Tipo de recurso: | artículo |
| Fecha de publicación: | 2021 |
| País: | España |
| Institución: | Varias* (Consorci de Biblioteques Universitáries de Catalunya, Centre de Serveis Científics i Acadèmics de Catalunya) |
| Repositorio: | Recercat. Dipósit de la Recerca de Catalunya |
| OAI Identifier: | oai:recercat.cat:20.500.14342/3943 |
| Acceso en línea: | http://hdl.handle.net/20.500.14342/3943 https://doi.org/10.3390/polym13111766 |
| Access Level: | acceso abierto |
| Palabra clave: | Additive manufacturing Material characterization Transverse isotropy Adhesion Mechanical properties Computational homogenization 66 |
| Sumario: | Process parameters in Additive Manufacturing (AM) are key factors in the mechanical performance of 3D-printed parts. In order to study their effect, a three-zone model based on the printing pattern was developed. This modelization distinguished three different zones of the 3D-printed part, namely cover, contour, and inner; each zone was treated as a different material. The cover and contour zones were characterized via uniaxial tensile tests and the inner zones via computational homogenization. The model was then validated by means of bending tests and their corresponding computational simulations. To reduce the number of required characterization experiments, a relationship between the raw and 3D-printed material was established by dimensional analysis. This allowed describing the mechanical properties of the printed part with a reduced set of the most influential non-dimensional relationships. The influence on the performance of the parts of inter-layer adhesion was also addressed in this work via the characterization of samples made of Polycarbonate Acrylonitrile Butadiene Styrene (ABS/PC), a polymeric material well known for its poor adhesion strength. It was concluded that by using this approach, the number of required testing configurations could be reduced by two thirds, which implies considerable cost savings. |
|---|