Superplastic Behavior of Overaged 2024 Aluminum Alloy after Friction Stir Processing
A commercial 2024 aluminum alloy was heat treated at 280 °C for 48 h and then slow cooled in a furnace to obtain minimum hardness. This material was then friction stir processed (FSP) using three sets of processing conditions. To study the effect of the processing on the microstructure and the high...
| Autores: | , , , |
|---|---|
| Tipo de recurso: | artículo |
| Estado: | Versión publicada |
| Fecha de publicación: | 2022 |
| País: | España |
| Institución: | Consejo Superior de Investigaciones Científicas (CSIC) |
| Repositorio: | DIGITAL.CSIC. Repositorio Institucional del CSIC |
| OAI Identifier: | oai:digital.csic.es:10261/287230 |
| Acceso en línea: | http://hdl.handle.net/10261/287230 |
| Access Level: | acceso abierto |
| Palabra clave: | Aluminum alloy Friction stir processing Mechanical properties Creep behavior Superplasticity |
| Sumario: | A commercial 2024 aluminum alloy was heat treated at 280 °C for 48 h and then slow cooled in a furnace to obtain minimum hardness. This material was then friction stir processed (FSP) using three sets of processing conditions. To study the effect of the processing on the microstructure and the high temperature mechanical properties, the materials were tested in tension at an initial strain rate of 10¿2 s¿1 and temperature range 200 to 450 °C. Processing severity was selected as the main factor for obtaining fine grain sizes right after FSP. The grain size was enormously reduced from about 50 µm to 1 µm. This grain reduction gave rise to very high elongations to failure of about 400%. Strain¿rate-change tests showed a stress exponent close to 2 at intermediate strain rates, which was related to grain boundary sliding as the controlling deformation mechanism and to su- perplasticity, which is strongly grain-size dependent. A possible controlling deformation mechanism by solute-drag creep, as proposed by other authors, was disregarded since tests conducted at 450 °C, where the microstructure of the FSP materials coarsens rapidly, gave a low elongation to failure and high resistance, which showed the importance of the grain size dependence of the operative deformation mechanism at 250¿400 °C, which was only compatible with grain boundary sliding. |
|---|