Comparison of the Musculoskeletal Effects of Different Iso-inertial Resistance Training Modalities: Flywheel vs. Electric-motor

[EN] This study aimed to analyse whether increasing the eccentric overload (EO) during resistance training, in terms of range of motion and/or velocity using an electric-motor device, would induce different muscle adaptations than conventional flywheel-EO resistance training. Forty physically active...

Descripción completa

Detalles Bibliográficos
Autores: Maroto Izquierdo, Sergio, Fernández Gonzalo, Rodrigo, Hashish, Magdi Rashad, Manzano Rodríguez, Saúl, González Gallego, Javier, Paz Fernández, José Antonio de
Tipo de recurso: artículo
Estado:Versión aceptada para publicación
Fecha de publicación:2019
País:España
Institución:Universidad Rey Juan Carlos
Repositorio:BULERIA. Repositorio Institucional de la Universidad de León
OAI Identifier:oai:buleria.unileon.es:10612/18084
Acceso en línea:https://www.tandfonline.com/doi/full/10.1080/17461391.2019.1588920
https://hdl.handle.net/10612/18084
Access Level:acceso abierto
Palabra clave:Deporte
Eccentric overload
Strength
Muscle power
Hypertrophy
Range of motion
32 Ciencias Médicas
2411.06 Fisiología del Ejercicio
2411 Fisiología Humana
Descripción
Sumario:[EN] This study aimed to analyse whether increasing the eccentric overload (EO) during resistance training, in terms of range of motion and/or velocity using an electric-motor device, would induce different muscle adaptations than conventional flywheel-EO resistance training. Forty physically active university students (21.7 ± 3.4 years) were randomly placed into one of the three training groups (EX1, EX2, FW) and a control group without training (n = 10 per group). Participants in the training groups completed 12 sessions (4 sets of 7 repetitions) of iso-inertial single-leg squat training over 6 weeks for the dominant leg. Resistance was generated either by an electric-motor device at two different velocities for the eccentric phase; 100% (EX1) or 150% (EX2) of concentric speed, or by a conventional flywheel device (FW). Thigh lean tissue mass, unilateral leg press one-repetition maximum (1-RM), unilateral muscle power at different percentages of the 1-RM and bilateral/unilateral vertical jump were assessed before and after the 6-week training. There were significant (p < 0.05–0.001) main effects of time in the 3 training groups, indicating increased thigh lean tissue mass (2.5–5.8%), 1-RM load (22.4–30.2%), vertical jump performance (9.1–32.9%) and muscle power (8.8–21.7%), without differences across experimental groups. Participants in the control group did not improve any of the variables measured. In addition, EX2 showed greater gains in eccentric average peak power during training than EX1 and FW (p < 0.001). Despite the different EO offered, 6 weeks of resistance training using flywheel or electric-motor devices induced similar significant gains in muscle mass, strength, muscle power and vertical jump.