Impact of Synthetic Paraffinic Kerosene Blends on the Injection Rate in Common-Rail Systems of Reciprocating Engines
This study analyzes the injection behavior of fossil and sustainable aviation fuel blends, in comparison with conventional diesel fuel, using a common-rail injection system applied to reciprocating engines. Neat commercial diesel and Jet A1 were tested as fossil fuels. A neat Fischer–Tropsch Synthet...
| Autores: | , , , , , |
|---|---|
| Tipo de recurso: | artículo |
| Fecha de publicación: | 2026 |
| País: | España |
| Institución: | Universidad de Castilla-La Mancha |
| Repositorio: | RUIdeRA. Repositorio Institucional de la UCLM |
| OAI Identifier: | oai:ruidera.uclm.es:10578/46818 |
| Acceso en línea: | https://www.mdpi.com/2076-3417/16/1/118 https://hdl.handle.net/10578/46818 |
| Access Level: | acceso abierto |
| Palabra clave: | Diesel Fuels Injection rate Kerosene Reciprocating engines |
| Sumario: | This study analyzes the injection behavior of fossil and sustainable aviation fuel blends, in comparison with conventional diesel fuel, using a common-rail injection system applied to reciprocating engines. Neat commercial diesel and Jet A1 were tested as fossil fuels. A neat Fischer–Tropsch Synthetic Paraffinic Kerosene was tested and blended with Jet A1. Another alternative fuel, Hydrotreated Vegetable Oil, was also blended with Jet A1. The blending proportion was established to meet 51 as the derived cetane number, as required for fuels used in diesel reciprocating engines. Experimental tests were carried out under an energizing time of 2 ms at injection pressures between 50 and 110 MPa, with a fuel temperature ranging from 293 to 313 K, and a constant back pressure of 5 MPa, using a 130 µm single-hole injector. The results show that kerosene fuel exhibits slightly lower injection rates and total injected mass than diesel fuel, mainly due to their lower density. Under low-pressure conditions, an increase in hydraulic injection delay with diesel fuel is observed, mainly at the highest tested temperature. Mass flow rate, hydraulic injection delay, injection duration, total mass injected, and nozzle discharge coefficient do not show significant variations within the tested temperatures. Fossil kerosene fuel and its blend with Synthetic Paraffinic Kerosene show slightly higher injection rates. Overall, the results indicate that both neat kerosene and the studied blends may achieve injection characteristics comparable to diesel fuel, supporting their technical feasibility in reciprocating engines within the framework of the Single Fuel Concept. Less |
|---|