Analog CMOS Readout Channel for Time and Amplitude Measurements With Radiation Sensitivity Analysis for Gain-Boosting Amplifiers
The front-end readout channel consists of a charge sensitive amplifier (CSA) and two different unipolar-shaping circuits to generate pulses suitable for time and energy measurement. The signal processing chain of the single channel is built of two different parallel processing paths: a fast path wit...
| Autores: | , , , , , |
|---|---|
| Tipo de recurso: | artículo |
| Estado: | Versión publicada |
| Fecha de publicación: | 2021 |
| País: | España |
| Institución: | Universidad de Sevilla (US) |
| Repositorio: | idUS. Depósito de Investigación de la Universidad de Sevilla |
| OAI Identifier: | oai:idus.us.es:11441/129989 |
| Acceso en línea: | https://hdl.handle.net/11441/129989 https://doi.org/10.1109/ACCESS.2021.3124644 |
| Access Level: | acceso abierto |
| Palabra clave: | Low power sensor interface circuits Analog front-end electronics Semiconductor detectors Complex shaper Charge sensitive amplifier |
| Sumario: | The front-end readout channel consists of a charge sensitive amplifier (CSA) and two different unipolar-shaping circuits to generate pulses suitable for time and energy measurement. The signal processing chain of the single channel is built of two different parallel processing paths: a fast path with a peaking time of 30 ns to obtain the time of arrival for each particle impinging the detector; and a slow path with a peaking time of 400 ns dedicated for low noise amplitude measurements, which is formed by a pole-zero cancellation circuit and a 4th order complex shaper based on a bridged-T architecture. The tunability of the system is accomplished by the discharge time constant of the CSA in order to accommodate various event rates. The readout system has been implemented in a 180 nm CMOS technology with the size of 525 μm x 290 μm . The building blocks use compact gain-boosting techniques based on quasi-floating gate (QFG) transistors achieving accurate energy measurement with good resolution. The high impedance nodes of QFG transistors require a detailed study of sensitivity to single-effect transients (SET). After carrying out this study, this paper proposes a method to select the value of the QFG capacitors, minimizing the area occupancy while maintaining robustness to radiation. The nonlinearity of the CSA-slow-shaper has been found to be less than 1% over a 10–70 fC input charge. The power dissipation of the readout channel is 4.1 mW with a supply voltage of 1.8 V. |
|---|