Optimization of micro single dielectric barrier discharge plasma actuator models based on experimental velocity and body force fields
Recently, the Micro Single Dielectric Barrier Discharge Plasma Actuator has become attractive for application in aeronautics and micropopulsion thrusters. The present work carried out a preliminary characterization of such device, acting on initially quiescent air by experimental and numerical appro...
| Autores: | , , , |
|---|---|
| Tipo de recurso: | artículo |
| Estado: | Versión aceptada para publicación |
| Fecha de publicación: | 2015 |
| País: | España |
| Institución: | Universidad Politécnica de Cartagena(UPCT) |
| Repositorio: | Repositorio Digital UPCT |
| OAI Identifier: | oai:repositorio.upct.es:10317/13363 |
| Acceso en línea: | http://hdl.handle.net/10317/13363 https://www.sciencedirect.com/science/article/pii/S0094576515002854 |
| Access Level: | acceso abierto |
| Palabra clave: | Micro SDBD DBD modeling Plasma-induced force Wall jet DBD microthruster Ingeniería Mecánica |
| Sumario: | Recently, the Micro Single Dielectric Barrier Discharge Plasma Actuator has become attractive for application in aeronautics and micropopulsion thrusters. The present work carried out a preliminary characterization of such device, acting on initially quiescent air by experimental and numerical approaches. Sinusoidal voltage excitation with amplitude up to 7 kV and frequency up to 2.5 kHz was applied. The induced flow was investigated by particle image velocimetry and the measured velocity fields were used to estimate experimentally the time-averaged induced body force distributions by a differential method. Plasma induced forces were modeled by following three different approaches, later implemented as a source term in the Navier–Stokes equations for the fluid flow simulations. Potentialities, advantages and disadvantages of the considered force modeling methods were investigated. Quantitative comparison of the experimental and numerical induced force, as well as of the velocity fields, allowed establishing which model best predicted the actuator effects. The algebraic Dual Potential Model provided a good agreement between experimental and simulated results, in terms of flow velocities and thickness of the induced wall-jet. The downstream decay of the wall-jet velocity, experimentally observed, was also successfully predicted. A maximum induced velocity of ≈2 m/s was obtained and a jet thickness of ≈3 mm. |
|---|