A simple and precise methodology to determine particulate matter mass in atmospheric filters
In the past decades, particulate matter (PM) measurements have been used extensively in atmospheric sciences, as it allows studying the evolution of tracers for different atmospheric processes and the effects of atmospheric pollution on human health. However, measuring PM mass requires a constant co...
| Autores: | , , , |
|---|---|
| Tipo de recurso: | artículo |
| Fecha de publicación: | 2022 |
| País: | España |
| Institución: | Universidad de Huelva (UHU) |
| Repositorio: | Arias Montano. Repositorio Institucional de la Universidad de Huelva |
| Idioma: | inglés |
| OAI Identifier: | oai:ariasmontano.uhu.es:10272/21430 |
| Acceso en línea: | https://hdl.handle.net/10272/21430 |
| Access Level: | acceso abierto |
| Palabra clave: | Particulate matter Atmospheric aerosols Atmospheric filters Gamma-ray spectrometry 7Be210Pb 22 Física |
| Sumario: | In the past decades, particulate matter (PM) measurements have been used extensively in atmospheric sciences, as it allows studying the evolution of tracers for different atmospheric processes and the effects of atmospheric pollution on human health. However, measuring PM mass requires a constant control of the laboratory conditions due to its capacity to absorb humidity. For this reason, this study was focused on developing a novel, simple and precise methodology to determine the corrections of the filter mass due to humidity changes. The control and corrections are possible using a “control filter”, which is always adapted to the environmental conditions of the laboratory. To check the consistency of this method, it was proved that the mass of any problem filter and that of the control filter behave in a very similar way. This allows quantifying the mass changes of any problem filter by using the control filter, where the problem filters and the control filter must have the same chemical composition and dimensions. To validate this methodology, a comparison was made between the methodology proposed in this study (Method-1) and the one proposed by the EPA (Method-2), which is generally applied. The particulate matter mass (m) was obtained for a problem filter for different weights, achieving similar values using both methods. However, Method-1 still provided reliable mass measurements for relative humidities very different from 50%, even as low as 18%. It was also proved that the adsorption or loss of water by the particulate matter can be neglected, since m is much smaller than the blank filter mass. Method-1 was also employed in several samplings carried out using three PM10 samplers to determine contaminants, such as 7Be and 210Pb, obtaining a good agreement between all particulate masses and activities measured by the three samplers for all samplings. |
|---|