Lab-scale experimental demonstration of Ca[sbnd]Cu chemical looping for hydrogen production and in-situ CO2 capture from a steel-mill
In the present work, a lab-scale packed bed reactor has been used to decarbonize mixtures of inlet gases simulating the typical composition of blast furnace gases (BFG) and convert them to H2-rich streams by means of the Ca[sbnd]Cu chemical looping concept. The reactor was packed with 355 g of Cu-ba...
| Autores: | , , , , , |
|---|---|
| Tipo de recurso: | artículo |
| Estado: | Versión publicada |
| Fecha de publicación: | 2022 |
| País: | España |
| Institución: | Consejo Superior de Investigaciones Científicas (CSIC) |
| Repositorio: | DIGITAL.CSIC. Repositorio Institucional del CSIC |
| OAI Identifier: | oai:digital.csic.es:10261/302994 |
| Acceso en línea: | http://hdl.handle.net/10261/302994 https://api.elsevier.com/content/abstract/scopus_id/85137308850 |
| Access Level: | acceso abierto |
| Palabra clave: | Blast furnace gas Chemical looping combustion Calcium‑copper looping CO2 capture Steel mill |
| Sumario: | In the present work, a lab-scale packed bed reactor has been used to decarbonize mixtures of inlet gases simulating the typical composition of blast furnace gases (BFG) and convert them to H2-rich streams by means of the Ca[sbnd]Cu chemical looping concept. The reactor was packed with 355 g of Cu-based oxygen carrier (OC) supported on Al2O3 and natural Ca-based sorbent. The three main reaction stages; namely (i) Calcium Assisted Steel-mill Off-gas Hydrogen (CASOH), (ii) Cu oxidation and (iii) Regeneration of carbonated Ca-based sorbent were examined. In CASOH stage, BFG is converted into H2-rich stream (17% by vol.) under the experimental conditions of 600 °C, 5.0 bar and S/CO molar ratio of 2.0. A controlled oxidation causes a mere 3.5% of CaCO3 to decompose during the Cu-oxidation stage. This resulted in a nearly pure N2 stream at 600 °C and 5.0 bar operating conditions. During the regeneration stage, BFG and mixture of BFG and CH4 is used as a reducing fuel. To ensure the amount of heat needed for the decomposition of CaCO3 during the reduction of CuO, a 1.4 CuO/CaCO3 molar ratio has been used. It resulted in 46% CO2 in N2 at the end of the reduction/calcination stage. |
|---|