Experimental and numerical insights on the in-plane behaviour of unreinforced and TRM/SRG retrofitted brick masonry walls by diagonal compression and shear-compression testing
The experimental determination of the parameters that characterise the in-plane shear behaviour of masonry structures is still a challenging task. Different authors have identified the key role of tensile strength in the definition of the in-plane shear behaviour of masonry, but unfortunately its di...
| Autores: | , , , |
|---|---|
| Tipo de recurso: | artículo |
| Fecha de publicación: | 2023 |
| País: | España |
| Institución: | Universitat Politècnica de Catalunya (UPC) |
| Repositorio: | UPCommons. Portal del coneixement obert de la UPC |
| Idioma: | inglés |
| OAI Identifier: | oai:upcommons.upc.edu:2117/393514 |
| Acceso en línea: | https://hdl.handle.net/2117/393514 https://dx.doi.org/10.1016/j.conbuildmat.2023.132997 |
| Access Level: | acceso abierto |
| Palabra clave: | Masonry -- Testing In-plane shear behaviour Tensile strength Masonry Textile Reinforced Mortar (TRM) Steel Reinforced Grout (SRG) Numerical simulation Estructures de murs Àrees temàtiques de la UPC::Enginyeria civil::Materials i estructures |
| Sumario: | The experimental determination of the parameters that characterise the in-plane shear behaviour of masonry structures is still a challenging task. Different authors have identified the key role of tensile strength in the definition of the in-plane shear behaviour of masonry, but unfortunately its direct experimental characterisation is not always feasible, and masonry’s tensile strength needs to be obtained from complex testing methodologies. As a result, tensile strength needs to be assessed from testing setups such as diagonal compression testing and shear compression testing when the failure mode of masonry is featured by tensile diagonal cracking. However, different formulations are available in the scientific literature regarding the interpretation of the experimental results derived from such tests. This work provides new insights on the interpretation of in-plane shear experimental behaviour of double-leaf historical clay brick masonry walls with low strength mortar joints, both unreinforced and retrofitted with textile reinforced mortar and steel reinforced grout. The research evaluates results derived from both testing methodologies, and investigates the potential correlation between them to fully characterise the in-plane shear behaviour of masonry walls. Finally, a numerical model is used to simulate each testing configuration and study the stress state at the centre of the walls to determine the tensile strength and its correlation with the shear strength and the maximum load attained. |
|---|