Analysis of GaN-Based HEMTs Operating as RF Detectors Over a Wide Temperature Range.
[EN]This paper presents an analysis of detection in the microwave region with AlGaN/GaN high-electron mobility transistors in terms of the key figures of merit: responsivity (both with voltage- and current-mode detection schemes) and noise equivalent power, in the temperature range between 20 and 40...
| Authors: | , , , , |
|---|---|
| Format: | article |
| Status: | Draft version |
| Publication Date: | 2023 |
| Country: | España |
| Institution: | Universidad de Salamanca (USAL) |
| Repository: | GREDOS. Repositorio Institucional de la Universidad de Salamanca |
| OAI Identifier: | oai:gredos.usal.es:10366/155349 |
| Online Access: | http://hdl.handle.net/10366/155349 |
| Access Level: | Open access |
| Keyword: | HEMTs Zero-bias detectors Transistors MODFETs Gallium Nitride Microwaves Semiconductors Transistors, Electronic 3307.08 Dispositivos de Microondas 3307.14 Dispositivos Semiconductores 3307.11 Receptores de Radio 3307.19 Transistores semiconductores transistores electrónicos microondas |
| Summary: | [EN]This paper presents an analysis of detection in the microwave region with AlGaN/GaN high-electron mobility transistors in terms of the key figures of merit: responsivity (both with voltage- and current-mode detection schemes) and noise equivalent power, in the temperature range between 20 and 400 K. Transistors with three different gates lengths (75, 150 and 250 nm) have been measured and favorably compared with a simple quasi-static model extracted from the DC curves, which is able to reproduce the zero-bias experiments at 1 GHz in the entire gate-bias sweep and operating temperature range. Such model allows to explain the detection experiments performed both with the devices operating in zero-current or zero-voltage conditions, and demonstrates that the bowing coefficient of the Id-Vds curves is the parameter which determines the performances of the devices as RF detectors. The voltage responsivity (in V/W) increases when the gate bias approaches the threshold voltage, but shows different behaviors in subthreshold conditions. Depending on whether the zero-current bias point is near zero drain voltage (for leaky devices, when the channel is not well pinched-off due to the short gate or to the conduction through the buffer at low temperature) or shifted to the point where third quadrant conduction starts (for well-behaved devices), the responsivity presents a decrease or an approximately constant value, respectively. On the other hand, when the detector is biased, the curves of current responsivity (in A/W) show a characteristic bell-shape with a maximum which is approximately the same for all tested devices and hardly depends on the gate bias (it is only shifted to different drain bias points). |
|---|