Estimation of the Latent Heat Flux over Irrigated Short Fescue Grass for Different Fetches
Often in agrometeorology the instrumentation required to estimate turbulent surface fluxes must be installed at sites where fetch is not sufficient for a sector of wind directions. For different integrated flux-footprints (IFFP) thresholds and taking as a reference the half-hourly latent heat fluxes...
| Autores: | , |
|---|---|
| Tipo de recurso: | artículo |
| Estado: | Versión publicada |
| Fecha de publicación: | 2021 |
| País: | España |
| Institución: | Universitat de Lleida (UdL) |
| Repositorio: | Repositori Obert UdL |
| OAI Identifier: | oai:repositori.udl.cat:10459.1/70918 |
| Acceso en línea: | https://doi.org/10.3390/atmos12030322 http://hdl.handle.net/10459.1/70918 |
| Access Level: | acceso abierto |
| Palabra clave: | Evapotranspiration Surface energy balance Weighing lysimeter Eddy covariance Surface renewal analysis |
| Sumario: | Often in agrometeorology the instrumentation required to estimate turbulent surface fluxes must be installed at sites where fetch is not sufficient for a sector of wind directions. For different integrated flux-footprints (IFFP) thresholds and taking as a reference the half-hourly latent heat fluxes (LE) measured with a large weighing lysimeter (LELys), the eddy covariance (EC) method and two methods based on surface renewal (SR) analysis to estimate LE were tested over short fescue grass. One method combined SR with the flux-gradient (profile) relationship, SR-P method, and the other with the dissipation method, SR-D method. When LE was estimated using traces of air moisture, good performances were obtained using the EC and the SR-P methods for samples with IFFP higher than 85%. However, the closest LE estimates were obtained using the residual method. For IFFP higher than 50%, the residual method combined with the sensible heat flux estimates determined using the SR-P method performed close to LELys and using the SR-D method good estimates were obtained for accumulated LELys. To estimate the sensible heat flux, the SR-D method can be recommended for day-to-day use by farmers because it is friendly and affordable. |
|---|