Fixed versus variable bulk canopy resistance for reference evapotranspiration estimation using the Penman-Monteith equation under semiarid conditions

In this paper, daily ET0 estimates at two semiarid locations, Zaragoza and Córdoba, were obtained from the Penman–Monteith equation using either fixed (70 s m−1) or variable rc values. Variable rc values were computed with two models, Katerji and Perrier, and Todorovic. Daily ET0 estimates were comp...

Descripción completa

Detalles Bibliográficos
Autores: Lecina Brau, Sergio, Martínez-Cob, Antonio, Pérez García, Pedro J., Villalobos, F. J., Baselga, J. J.
Tipo de recurso: artículo
Estado:Versión aceptada para publicación
Fecha de publicación:2003
País:España
Institución:Universitat de Lleida (UdL)
Repositorio:Repositori Obert UdL
OAI Identifier:oai:repositori.udl.cat:10459.1/65078
Acceso en línea:https://doi.org/10.1016/S0378-3774(02)00174-9
http://hdl.handle.net/10459.1/65078
Access Level:acceso abierto
Palabra clave:Canopy resistance
Evapotranspiration
Penman–Monteith equation
Descripción
Sumario:In this paper, daily ET0 estimates at two semiarid locations, Zaragoza and Córdoba, were obtained from the Penman–Monteith equation using either fixed (70 s m−1) or variable rc values. Variable rc values were computed with two models, Katerji and Perrier, and Todorovic. Daily ET0 estimates were computed from 24-h meteorological averages or from the sum of hourly estimates. Daily ET0 measured values were obtained from a weighing lysimeter (Zaragoza) and an eddy covariance system (Córdoba). There was a good agreement at both locations between estimated and measured ET0 values using a fixed rc value and 24-h meteorological averages. Estimates obtained from the sum of hourly estimates were somewhat worse. When 24-h meteorological averages were used, the Katerji and Perrier model for variable rc slightly improved ET0 estimates at both locations. But that improvement does not support the effort to locally calibrate that model. When daily ET0 estimates were obtained from the sum of hourly estimates, the Todorovic model improved the estimation at Zaragoza and, at a lesser degree, at Córdoba. Under the semiarid conditions of the two studied locations, the use of the Todorovic model is recommended to get hourly ET0 estimates from which daily estimates can be obtained. If 24-h meteorological averages are used, a fixed rc value as proposed by Allen et al. [Crop evapotranspiration: guidelines for computing crop water requirements, FAO Irrigation and Drainage Paper No. 56, FAO, Rome, 1998] should be enough for accurate ET0 estimates.