Estimation of shrub biomass by airborne LiDAR data in small forest stands
The presence of shrub vegetation is very significant in Mediterranean ecosystems. However, the difficulty involved in shrub management and the lack of information about behavior of this vegetation means that these areas are often left out of spatial planning projects. Airborne LiDAR (Light Detection...
| Autores: | , , , |
|---|---|
| Tipo de recurso: | artículo |
| Fecha de publicación: | 2011 |
| País: | España |
| Institución: | Universitat Politècnica de València (UPV) |
| Repositorio: | RiuNet. Repositorio Institucional de la Universitat Politécnica de Valéncia |
| Idioma: | inglés |
| OAI Identifier: | oai:riunet.upv.es:10251/47019 |
| Acceso en línea: | https://riunet.upv.es/handle/10251/47019 |
| Access Level: | acceso abierto |
| Palabra clave: | Biomass DTM Forest management LiDAR Shrub Airborne LiDAR Airborne lidar data Dominant species Dry biomass Field measurement Forest stand Forest structure High density LIDAR data Little research Mediterranean ecosystem Mediterranean forest Quercus Small area Spatial planning Standard deviation Estimation Forestry Planning Temperature control Vegetation Optical radar Accuracy assessment Clearcutting Cost-benefit analysis Data set Deciduous forest Dominance Error analysis Estimation method Forest ecosystem Height determination Mediterranean environment Phytomass Prediction Stand structure Quercus coccifera INGENIERIA AGROFORESTAL INGENIERIA CARTOGRAFICA, GEODESIA Y FOTOGRAMETRIA |
| Sumario: | The presence of shrub vegetation is very significant in Mediterranean ecosystems. However, the difficulty involved in shrub management and the lack of information about behavior of this vegetation means that these areas are often left out of spatial planning projects. Airborne LiDAR (Light Detection And Ranging) has been used successfully in forestry to estimate dendrometric and dasometric variables that allow to characterize forest structure. In contrast, little research has focused on shrub vegetation. The objective of this study was to estimate dry biomass of shrub vegetation in 83 stands of radius 0.5 m using variables derived from LiDAR data. Dominant species was Quercus coccifera, one of the most characteristic species of the Mediterranean forests. Density of LiDAR data in the analyzed stands varied from 2 points/m(2) to 16 points/m(2), being the average 8 points/m(2) and the standard deviation 4.5 points/m(2). Under these conditions, predictions of biomass were performed calculating the mean height, the maximum height and the percentile values 80th, 90th, and 95th derived from LiDAR in concentric areas whose radius varied from 0.50 m to 3.5 m from the center of the stand. The maximum R(2) and the minimum RMSE for dry biomass estimations were obtained when the percentile 95th of LiDAR data was calculated in an area of radius 1.5 m, being 0.48 and 1.45 kg, respectively. For this radius, it was found that for the stands (n = 39) where the DTM is calculated with high accuracy (RMSE lower than 0.20 m) and with a high density of LiDAR data (more than 8 points/m(2)) the R(2) value was 0.73. These results show the possibility of estimating shrub biomass in small areas when the density of LiDAR data is high and errors associated to the DTM are low. These results would allow us to improve the knowledge about shrub behavior avoiding the cost of field measurements and clear cutting actions. (C) 2011 Elsevier B.V. All rights reserved. |
|---|