Comparison of Microencapsulated Phase Change Materials Prepared at Laboratory Containing the Same Core and Different Shell Material
Microencapsulated Phase Change Materials (MPCM) are widely used in active and passive systems for thermal energy storage. To evaluate the strength of a proper shell/PCM system, comparisons were performed between laboratory-prepared MPCM samples produced by in situ polymerization with a phase change...
| Autores: | , , , |
|---|---|
| Formato: | artículo |
| Estado: | Versión publicada |
| Fecha de publicación: | 2017 |
| País: | España |
| Recursos: | Varias* (Consorci de Biblioteques Universitáries de Catalunya, Centre de Serveis Científics i Acadèmics de Catalunya) |
| Repositorio: | Recercat. Dipósit de la Recerca de Catalunya |
| OAI Identifier: | oai:recercat.cat:2445/184977 |
| Acesso em linha: | https://hdl.handle.net/2445/184977 |
| Access Level: | acceso abierto |
| Palavra-chave: | Emmagatzematge d'energia tèrmica Propietats tèrmiques Microencapsulació Heat storage Thermal properties Microencapsulation |
| Resumo: | Microencapsulated Phase Change Materials (MPCM) are widely used in active and passive systems for thermal energy storage. To evaluate the strength of a proper shell/PCM system, comparisons were performed between laboratory-prepared MPCM samples produced by in situ polymerization with a phase change temperature of 50 degrees C and a particle size of around 1-2 mu m with tetracosane as PCM, and polystyrene (PS) and poly (methyl methacrylate) (PMMA) as shells. Evaluation of mechanical performance was performed for different samples by means of Atomic Force Microscopy (AFM) at different temperatures (23 degrees C and 60 degrees C) and with different encapsulation ratios (1:3 and 1:1, shell:core) in order to compare their properties with the PCM below and above its phase change. Evaluations of the Effective Young's modulus (E) and deformation properties were performed for both types of MPCM. For an encapsulation mass ratio of 1:3, PS has better mechanical properties because, when increasing the temperature, the E decreases less than with PMMA. In the comparison between PS/tetracosane systems with different encapsulation mass ratios (1:3 and 1:1), E values were higher for the 1:3 encapsulation mass ratio at both temperatures under study. This means that, in terms of mechanical and thermal properties, the best combination core/shell/encapsulation mass ratio is PS/tetracosane/1:3. |
|---|