Influence stacking sequence and heat treatments on the out-of-plane mechanical properties of 3D-printed fiberglass-reinforced thermoplastics
Additive manufacturing of composite materials is a promising technology. It could solve one of the most critical drawbacks of 3D-printed fiber-reinforced thermoplastics: their low out-of-plane mechanical properties. Due to this factor, it is still unknown how most design and manufacturing parameters...
| Autores: | , , , , , , , , , |
|---|---|
| Tipo de recurso: | artículo |
| Estado: | Versión aceptada para publicación |
| Fecha de publicación: | 2023 |
| País: | España |
| Institución: | Universidad Pública de Navarra |
| Repositorio: | Academica-e. Repositorio Institucional de la Universidad Pública de Navarra |
| OAI Identifier: | oai:academica-e.unavarra.es:2454/56119 |
| Acceso en línea: | https://hdl.handle.net/2454/56119 |
| Access Level: | acceso abierto |
| Palabra clave: | Fused filament fabrication Interlaminar strength Stacking sequences Void reduction |
| Sumario: | Additive manufacturing of composite materials is a promising technology. It could solve one of the most critical drawbacks of 3D-printed fiber-reinforced thermoplastics: their low out-of-plane mechanical properties. Due to this factor, it is still unknown how most design and manufacturing parameters affect the out-of-plane properties of composite materials. As a solution, this paper proposes an experimental methodology to characterize out-of-plane printed composite materials. For this purpose, existing standards for traditionally fabricated composites are adapted, investigated, and validated for 3D-printed laminates reinforced with long fibers using the fused filament fabrication technique. Consequently, the methodology is employed to study the impact of stacking sequence and heat treatment conditions on the composites¿ out-of-plane mechanical properties. The main results showed that increasing the thickness between stacking layers increases the mechanical response due to reducing the number of fiber/matrix interfaces and, consequently, the reduction of porosity. Compared to the initial sample, a heat treatment at 175 °C for 6 h increased the interfacial strength by 101.09% and reduced the porosity in the fiber produced by the additive manufacturing process by 72%. |
|---|