Notch Fracture in Polymeric Specimens under Compressive Stresses: The Role of the Equivalent Material Concept in Estimating the Critical Stress of Polymers
ABSTRACT: n this paper, the fracture of notched polymeric specimens under compressive stresses was investigated both experimentally and theoretically. In the experimental section, to determine the load-carrying capacity (LCC) of U-notched specimens made of general-purpose polystyrene (GPPS) and poly...
| Autores: | , , , |
|---|---|
| Formato: | artículo |
| Fecha de publicación: | 2021 |
| País: | España |
| Recursos: | Universidad de Cantabria (UC) |
| Repositorio: | UCrea Repositorio Abierto de la Universidad de Cantabria |
| Idioma: | inglés |
| OAI Identifier: | oai:repositorio.unican.es:10902/23788 |
| Acesso em linha: | http://hdl.handle.net/10902/23788 |
| Access Level: | acceso abierto |
| Palavra-chave: | Brittle fracture U-notch Compressive loading Equivalent material concept (EMC) Maximum tangential stress (MTS) criterion Mean stress (MS) criterion |
| Resumo: | ABSTRACT: n this paper, the fracture of notched polymeric specimens under compressive stresses was investigated both experimentally and theoretically. In the experimental section, to determine the load-carrying capacity (LCC) of U-notched specimens made of general-purpose polystyrene (GPPS) and polymethyl-methacrylate (PMMA) polymers, tests were performed on notched square samples under compression, i.e., negative mode I loading. In the observation of the nonlinear behavior of the two polymers in the standard compressive tests, for the first time, the equivalent material concept (EMC) was used under compressive loading to theoretically estimate the critical stresses of the two polymers, which were shown to be significantly different from the ultimate strengths obtained from the standard compression tests. By linking the EMC to the maximum tangential stress (MTS) and mean stress (MS) criteria, the LCC of the notched specimens was predicted. The outcomes are twofold: First, MTS, MS, EMC-MTS, and EMC-MS criteria provide accurate predictions of the experimental critical loads observed in the U-notched polymeric specimens; second, the combination of the EMC with the MTS and MS criteria, allow such predictions to be obtained without any need for experimental calibration. |
|---|