PtRu nanoparticles supported on noble carbons for ethanol electrooxidation
In this work, three cytosine derived nitrogen doped carbonaceous materials (noble carbons, NCs) with different atomic C/N ratios and porous networks have been synthesized and used as supports for PtRu electrocatalysts in the ethanol oxidation reaction (EOR) for clean hydrogen production. Both, the m...
| Autores: | , , , , |
|---|---|
| Tipo de recurso: | artículo |
| Fecha de publicación: | 2022 |
| País: | España |
| Institución: | Universidad de Castilla-La Mancha |
| Repositorio: | RUIdeRA. Repositorio Institucional de la UCLM |
| OAI Identifier: | oai:ruidera.uclm.es:10578/29913 |
| Acceso en línea: | https://hdl.handle.net/10578/29913 |
| Access Level: | acceso abierto |
| Palabra clave: | Noble carbon Cytosine H2 production Ethanol electrooxidation PtRu anode PEM cell Carbono noble Citosina Producción de H2 Electrooxidación de etanol Ánodo PtRu Celda PEM |
| Sumario: | In this work, three cytosine derived nitrogen doped carbonaceous materials (noble carbons, NCs) with different atomic C/N ratios and porous networks have been synthesized and used as supports for PtRu electrocatalysts in the ethanol oxidation reaction (EOR) for clean hydrogen production. Both, the metal phase and the carbon support play critical roles in the electrocatalysts final performance. Lower NPs size distribution was obtained over supports with low atomic C/N ratios (i.e., 4 and 6) and defined porosity (i.e., 1701 m2 g−1 for PtRu/CNZ and 1834 m2 g−1 for PtRu/CLZ, respectively). In contrast, a lower C/N ratio and poor porous network (i.e., 65 m2 g−1, PtRu/CLK) led to the largest particle size and fostered an increase of the alloying degree between Pt and Ru NPs (i.e., 3% for C/N ~ 6 and 28% for C/N ~ 3). Electrochemical active surface area was found to increase with decreasing NPs size and the alloy extent, due to a higher availability of Pt active sites. Accelerated degradation tests showed that PtRu/NCs outperform similar to PtRu NPs on commercial carbon pointing at the stabilizing effect of NCs. PtRu/CNZ exhibited the best electrochemical performance (i.e., 69.1 mA mgPt−1), outperforming PtRu/CLZ and PtRu/CLK by 3- and 9-fold, respectively, due to a suitable compromise between particle sizes, degree of alloy, textural properties and elemental composition. Best anodes were scaled-up to a proton exchange membrane cell and PtRu/CNZ was proved to provide the best electrocatalytic activity (262 mA cm−2 and low energy requirements), matching the values obtained by the state of the art of EOR electrocatalysts. |
|---|