Study of graphene dispersions in sodium dodecylsulfate by steady-state fluorescence of pyrene
Hypothesis: Aqueous solutions of ionic surfactants allow the exfoliation of graphene, that can be explained considering the adsorption model of ionic surfactants to hydrophobic surfaces. For many years, pyrene has been used as a fluorescent probe because its sensitivity to the micro-environment. The...
| Autores: | , , , , |
|---|---|
| Formato: | artículo |
| Fecha de publicación: | 2018 |
| País: | España |
| Recursos: | Universidad de Alcalá (UAH) |
| Repositorio: | e_Buah Biblioteca Digital Universidad de Alcalá |
| Idioma: | inglés |
| OAI Identifier: | oai:ebuah.uah.es:10017/59818 |
| Acesso em linha: | http://hdl.handle.net/10017/59818 https://dx.doi.org/10.1016/j.jcis.2017.12.052 |
| Access Level: | acceso abierto |
| Palavra-chave: | Graphene SDS Pyrene Dispersion Fluorescence quenching Química Chemistry |
| Resumo: | Hypothesis: Aqueous solutions of ionic surfactants allow the exfoliation of graphene, that can be explained considering the adsorption model of ionic surfactants to hydrophobic surfaces. For many years, pyrene has been used as a fluorescent probe because its sensitivity to the micro-environment. The study of pyrene fluorescence in the presence of different graphene dispersions in an ionic surfactant, would improve the knowledge of the graphene-surfactant interactions.Experiments: Different dispersions of graphene in sodium dodecylsulfate were prepared at different weight ratios 0.5, 1 and 2%. The dispersions have been studied by Raman spectroscopy, scanning electron microscopy and transmission electron microscopy. The influence of the dispersions on the pyrene fluorescence has been investigated.Findings: The graphene sheets modified by the surfactant quench the fluorescence of pyrene, which depends on the amount of graphene, the concentration of surfactant and the weight ratio. For surfactant concentrations below the critical micelle concentration, the quenching effect is higher as the weight ratio increases. Once this concentration is reached, the fluorescence increases slightly and then levels off. This behavior has been explained by the adsorption model. For a constant surfactant concentration, twostraight lines can be observed in the Stern-Volmer plots whose cut-off point is approximately 20 mg L-1 of graphene. |
|---|