Use of ash from sewage sludge in the preparation of desulfurant sorbents
This work aims to develop new uses for sewage sludge, which is a byproduct of municipal wastewater treatment plants, by examining the calcination of this waste, the characterization of ashes is obtained, and its use to prepare desulfurant sorbents. Samples of sewage sludge were obtained from a local...
| Autores: | , , , |
|---|---|
| Tipo de recurso: | artículo |
| Fecha de publicación: | 2010 |
| País: | España |
| Institución: | Universidad de Cantabria (UC) |
| Repositorio: | UCrea Repositorio Abierto de la Universidad de Cantabria |
| Idioma: | inglés |
| OAI Identifier: | oai:repositorio.unican.es:10902/1880 |
| Acceso en línea: | http://hdl.handle.net/10902/1880 |
| Access Level: | acceso abierto |
| Palabra clave: | Sewage sludge Calcination Desulfurization sorbent |
| Sumario: | This work aims to develop new uses for sewage sludge, which is a byproduct of municipal wastewater treatment plants, by examining the calcination of this waste, the characterization of ashes is obtained, and its use to prepare desulfurant sorbents. Samples of sewage sludge were obtained from a local municipal wastewater treatment plant. This plant applies a pre-treatment followed by a biological treatment, where anaerobic digestion and centrifugation reduces the sludge. Three samples were characterized (in humidity, volatile and fixed solids content), dried, and ignited at two temperatures, 550 and 750 C. The composition of the ash obtained at both ignition temperatures was studied by x-ray fluorescent spectroscopy and the BET specific surface area of the two ashes and of the prepared sorbents was measured. Ash composition was similar for the two temperatures tested, where the components were Si, Ca, Al, Fe, P, S, Mg, K, Cl, Zn and Ti. BET specific surface area values indicate that the lower temperature of calcination produces ash with the highest SSA values (18 m2/g against near 10 m2/g). Preparation of desulfurant sorbents was carried out by mixing the ash with CaO or Ca(OH)2 at room temperature and different experimental conditions. The BET SSA of the prepared desulfurant sorbents showed higher values for the sorbents prepared with the ashes obtained at the lowest temperature. The behaviour of the ash and the prepared sorbents was tested in a fixed bed reactor at 58 C with a flue gas containing 5000 ppm of SO2 with a relative humidity of 55%. Results in the desulfurization process show that the calcium from the sludge seems more efficient than the calcium added as CaO or Ca(OH)2 to prepare the sorbents. |
|---|