Variable rate sprayer. Part 1 – Orchard prototype: design, implementation and validation
Discussions in recent decades about dosage models for applying plant protection products in orchards have failed to reach a compromise solution. Furthermore, canopies are spatially variable, and a uniform dose may not be adequate for the entire orchard. Spraying at an adequate volume application rat...
| Autores: | , , , , , , , |
|---|---|
| Tipo de recurso: | artículo |
| Estado: | Versión aceptada para publicación |
| Fecha de publicación: | 2013 |
| País: | España |
| Institución: | Universitat de Lleida (UdL) |
| Repositorio: | Repositori Obert UdL |
| OAI Identifier: | oai:repositori.udl.cat:10459.1/49470 |
| Acceso en línea: | https://doi.org/10.1016/j.compag.2013.02.004 http://hdl.handle.net/10459.1/49470 |
| Access Level: | acceso abierto |
| Palabra clave: | Precision horticulture Variable rate LiDAR sensor Orchard sprayer Polvorització (Agricultura) Radar òptic |
| Sumario: | Discussions in recent decades about dosage models for applying plant protection products in orchards have failed to reach a compromise solution. Furthermore, canopies are spatially variable, and a uniform dose may not be adequate for the entire orchard. Spraying at an adequate volume application rate on a site-specific basis would help reduce the amount of agrochemicals used in the framework of precision horticulture and precision fructiculture. An orchard sprayer prototype running a variable-rate algorithm to adapt the volume application rate to the canopy volume in orchards on a real-time and continuous basis was designed, implemented, and validated. An equivalent prototype was designed for vineyards and described in a companion paper (‘Variable rate sprayer. Part 2 – Vineyard prototype: Design, implementation and validation’). The orchard prototype was divided into three parts: the canopy characterization system (using a LiDAR sensor), the controller executing a variable-rate algorithm, and the actuators. The controller determines the intended flow rate by using an application coefficient (required liquid volume per unit canopy volume) to convert canopy volume into a flow rate. The sprayed flow rates are adjusted via electromagnetic variable-rate valves. The goal of the prototype was to keep the actual application coefficients as close as possible to the objective. Strong relationships were observed between the intended and the sprayed flow rates (R2 = 0.935) and between the canopy cross-sectional areas and the sprayed flow rates (R2 = 0.926). In addition, when spraying in variable-rate mode, the prototype achieved significantly closer application coefficient values to the objective than those obtained in conventional spraying application mode. |
|---|