Estudo do acoplamento entre superfícies seletivas de frequência assimétricas em estruturas de multicamadas
This work presents the development of new microwaves structures, filters and high gain antenna, through the cascading of frequency selective surfaces, which uses fractals Dürer and Minkowski patches as elements, addition of an element obtained from the combination of the other two simple the cross d...
| Autor: | |
|---|---|
| Formato: | tesis doctoral |
| Estado: | Versión publicada |
| Fecha de publicación: | 2012 |
| País: | Brasil |
| Recursos: | Universidade Federal do Rio Grande do Norte (UFRN) |
| Repositorio: | Repositório Institucional da UFRN |
| Idioma: | portugués |
| OAI Identifier: | oai:repositorio.ufrn.br:123456789/15185 |
| Acesso em linha: | https://repositorio.ufrn.br/jspui/handle/123456789/15185 |
| Access Level: | acceso abierto |
| Palavra-chave: | FSS fractal de Minkowski fractal de Dürer FSS dissimilares acopladas FSS de multicamadas minkowski fractal koch fractal coupled dissimilar FSS multilayer FSS CNPQ::ENGENHARIAS::ENGENHARIA ELETRICA |
| Resumo: | This work presents the development of new microwaves structures, filters and high gain antenna, through the cascading of frequency selective surfaces, which uses fractals Dürer and Minkowski patches as elements, addition of an element obtained from the combination of the other two simple the cross dipole and the square spiral. Frequency selective surfaces (FSS) includes a large area of Telecommunications and have been widely used due to its low cost, low weight and ability to integrate with others microwaves circuits. They re especially important in several applications, such as airplane, antennas systems, radomes, rockets, missiles, etc. FSS applications in high frequency ranges have been investigated, as well as applications of cascading structures or multi-layer, and active FSS. In this work, we present results for simulated and measured transmission characteristics of cascaded structures (multilayer), aiming to investigate the behavior of the operation in terms of bandwidth, one of the major problems presented by frequency selective surfaces. Comparisons are made with simulated results, obtained using commercial software such as Ansoft DesignerTM v3 and measured results in the laboratory. Finally, some suggestions are presented for future works on this subject |
|---|